If you need to keep your motor warm we can make a custom heated cover to fit it. Our heated outboard covers are used in the harshest of environments by military and commercial customers, testimonials and reports from them confirm the ability of these covers to maintain ‘operational readiness’ in some of the most extreme environments on the planet.
We offer a 2 layer cover for temperatures down to 14F and a 3 layer (with thermal insulation) for as low as -25F. They can also be made as an all over ‘Full’ cover or a top section ‘Mooring’ cover (leaves the bottom 1/3 of the leg exposed).
The gallery below has some examples of our heated covers. Please use the contact form below to send us your details, we will then provide a custom quote.
Price example, 150hp motor – Full (all over) heated storage cover:-
2 Layer, suitable for +32 to +14F $870
3 Layer, (inc thermal layer) +14 to -22F $1,044
We have designed a heating system that we can fit into one of our Full outboard covers. These were originally developed for military use in the Arctic (-60 degrees!) but we have a version for less aggressive climate protection.
Our heated covers are made to order and to your specific requirements. The heating system is regulated to maintain a designated temperature and have thermal cut outs to protect from over heating.
We used a silicone heat pad that can be built to run on most voltages. We would not recommend using over 110V or 240V for safety reasons. If operating in extreme cold (less than -15 degrees) we can also supply Arctic rated cable and plugs.
Heated covers are supplied without any electrical connections (plugs). Plugs and transformers will have to be sourced locally and in accordance with safety regulations.
Click on any image below for more information.
I am happy to tell you all of the covers performed exceptionally well throughout the episodes of subfreezing temperatures. The wind chill factor dropped the temperature to -20c. All interior ambient engine air temperatures were measured from 2-3c. Well done sir.
I am going to recommend immediate accession of the covers for permanent inventory. I will be requesting additional covers in the July-August time frame. I look forward to working with you again James. Thank you for enabling this success.
All our heated covers are made to customer specific requirements as temperatures, voltages and environmental conditions vary. Please complete the form below and we will contact you with draft pricing or to get further information. NOTE:- We cannot make heated covers for some motors below 40hp due to size restrictions.